Drive system |
Digital Servo Motor |
Maximum cutting area |
14.76 inches wide by 164.04 feet long (375mm x 50M) |
Range of guaranteed precision |
14.015 x 78.74 inches (356mm x 2M) *1 |
Compatible Media widths |
Min: 1.968 inches (50mm) Max: 19.055 inches (484mm) |
Carrier Sheet |
A3 size: 11.7 x 16.5 inches (297 x 420mm) |
Maximum media thickness |
.25mm |
Maximum cutting speed (all directions) |
23.62 ips (60 cm/s) |
Maximum Acceleration (45° Angle) |
16.4 ft/sec^2 (5 m /sec^2) |
Selectable Cutting Speeds |
1–10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 cm/s |
Cutting Force (31 levels) |
20 gf to 300 gf |
Minimum Character size |
0.196 inches (5mm) for Alphanumeric characters
(varies depending on the media, font style, etc.) |
Mechanical resolution |
0.000196 inches (0.005 mm) |
Programmable resolution |
GP-GL: 254/508/1016/2540 ppi
HP-GL™ *emulation: 1016 ppi |
Repeatability precision |
0.1 mm or less per 2M *1 |
Number of Pens or Blades Mountable |
1 pen or Blade Holder at a time |
Blade Type |
Tungsten Carbide blade, 0.9mm to 1.5mm (see Accy List.)
|
Compatible Plotting Pen Type |
Water-based fiber-tip pens |
Compatible Media |
Sheet or Roll media including marking films (PVC, fluorescent, or reflective film)
up to0.25 mm in thickness (excluding high-intensity reflective film), heat and
image transfer papers with backing, craft paper with backing, card stock, kent
paper, decorative media and papers with use of carrier sheet. |
Control Interface (selectable) |
USB 2.0 / RS-232C / Centronics Parallel |
Interface Buffer capacity |
2 MB |
Command modes (Selectable) |
GP-GL, HP-GL*2 |
Display Panel |
Liquid Crystal Display (16 characters x 1 row) |
Power Supply Rating |
100~120VAC 200~240VAC 50/60 Hz |
Power consumption |
100 VA |
Max. Operating Environment |
50° F to 95° F (10°C to 35°C) |
Recommended Environment |
60° F to 89.6° F (16°C to 32°C) |
Relative Humidity |
(35% to 75% RH non-condensing) |
External Dimensions (W x D x H) |
24.53 x 11.22 x 8.78 inches (623 x 285 x 223mm) |
Unit Weight |
20.72 Lbs (9.4 kg) |
*1: Depends on type of approved media and cutting conditions
*2: HP-GL is a registered trademark of Hewlett-Packard Company |
