Graphtec Craft ROBO Driver OPS653 Ver. 4.00B
for Microsoft Windows 2000 / Windows XP / Windows Vista / Windows 7

Thank you for choosing the Graphtec OPS653 Craft ROBO Driver. 

The README.TXT file in each directory contains instructions on installation and
operation as well as other notes. Be sure to read them carefully before 
installing or using this driver.

Before you begin installation, check that the program disk contains the 
following:

  WIN2K_VISTA\DISK1            For Windows 2000 /
  WIN2K_VISTA\GPCR.GPD             Windows XP /
  WIN2K_VISTA\CC300.GPD            Windows Vista /
  WIN2K_VISTA\CC300L.GPD           Windows 7 (32bits Edition)
  WIN2K_VISTA\CC330.GPD
  WIN2K_VISTA\CC330L.GPD
  WIN2K_VISTA\GPCR.INF
  WIN2K_VISTA\GPCR.CAT
  WIN2K_VISTA\GPCR.DLL
  WIN2K_VISTA\GPCRUI.DLL
  WIN2K_VISTA\GPCRUI.CHM
  WIN2K_VISTA\GTCCRMON.DLL
  WIN2K_VISTA\README.TXT

Required PC specifications
(The specication needs to be higher than recommended specification
 by using OS)

* OS             : Windows 2000�^Windows XP�^Windows Vista
* CPU            : Pentium III 800MHz or faster
* Memory         : 512MB or larger
* Display        : 1024x768 True Color
* Mouse
* CD-ROM drive
* USB interface  : USB2.0(Full Speed)
Note:
 The interface which can be used depends on the plotter model.
 The plotter needs to be connected with either interface.

Precautions to be observed when connecting the Graphtec Craft ROBO
via USB.
   * The Graphtec Craft ROBO does not operate under Windows 3.1/95/98/98SE/Me
     or Windows NT.
   * Operation with other than the included driver is not guaranteed.
   * Do not connect multiple plotters to a single computer.
   * Operation is not guaranteed if the plotter is connected to a USB hub
     or to a USB extension board.

END