Installation Space
Sufficient space must be left in front of, behind, and at both sides of the printer not only for normal operating procedures such as the replacement of consumable, the handling of printed materials, and for ventilation, but also for the replacement of parts in the event of a malfunction. Ensure that the space left around the printer is as shown in the following diagram.
Do not install the printer in an unsteady location such as on a rickety base or on a sloping surface.
There is a risk of injury if the printer falls or topples over.
Use the printer in the following temperature and humidity ranges.
Temperature: 20 - 28°C
Humidity: 40 - 70% (non-condensing)
Power Supply Specifications
The power supply specifications for this printer are as follows. Make sure that the power supply used
conforms to the printer specifications.
- Printer control power supply: 220 VAC, 50/60Hz
- Heater power supply: 220 VAC, 50/60Hz
- Drying fan power supply: 220 VAC, 50/60Hz
*Power Supply Precautions:
- Install the printer near a power outlet that is within easy reach.
- Do not connect the printer to the same power supply line that is used for noise-generating devices such as photocopying machines, air conditioners and motors.
-
Connect the printer to a separate power outlet. Do not connect other devices to the same power outlet.
