Execute the Moving Test to ensure that the lubricating oil is spread evenly on the print head carriage rails and the feed rollers.
- If the power is turned off, turn it on.
- ISince ink has not yet been supplied to the printer, a “No Ink” alarm will sound after several minutes have elapsed.
This alarm does not indicate a malfunction, and no action is required.
Executing the moving test
- From the main menu, select [Engineer Set] and then press the ENTER key.
- From the submenu, select [Moving Test] and then press the ENTER key.
- Let the operation continue for approximately 15 minutes.
Check that there are no abnormalities during the moving test operation.
If there are any abnormalities such as an unusual noise or if the printer doesn’t operate, turn off the power
supply and contact your sales representative or nearest Graphtec vendor.
- End the Moving Test.
Press the ESC key to end the moving test. When the test has ended, return to the main menu.
Hold down the ESC key until the print head carriage stops at the Home position.
|
|
Copyright Graphtec Corporation All rights reserved.
