6. Initial Ink Induction Procedure

6-1. Initial Cleaning of the Ink Supply Tubes and the Sub Tanks

Connecting the inlet tubes

  1. Open the rear panel, and then remove the two screws holding rear of the main board cover.
  2. Open the front panel.
  3. Detach the main board cover.
  1. Remove the two screws holding the fixer, and then detach the fixer.
  2. Attach the four inlet tubes provided to the 3-way valves on the print head carriage.
    Make sure that the tubes are firmly connected to the 3-way valve.
  1. Put the inlet tube through bottom of a board, and wire it forward.
  2. Set the 3-way valve for each ink tank to the ink supply position.
  1. Turn on the printer power supply.
    When the power is turned on, the printer begins a self-test operation (the print head carriage and the feed rollers move). When the self test has been completed, wait until the main menu is displayed on the LCD.