6. Initial Ink Induction Procedure

6-3. Mounting the Print heads

  1. Write down the print head mounting position and the serial number.
    These will be required for a later procedure.
  1. Attach an out let tube and tube clamper (provided as accessories) to the print head. Leave the tube clamper open.

  2. Remove the caps attached to the print head, and then insert the inlet tube and outlet tube into the print head inlet.

    caution
    Do not mistake the color of tubes when connecting the inlet tubes.

  3. Attached to the print head clamper to the print head and the inlet tube joints.
  1. Loosen the top and the left screws, and remove the right screw.
  2. Mount the print head, and then reattach the right screw.
  3. Tighten the top, left and right screws to fasten the print head in place.